Technical data sheets
Copper and Copper Alloys | Phosphor & Leaded Bronze
ASNA 3406G
An Aluminium Bronze alloy formulated specifically for use on the Airbus A380 programme.
Chemical Composition
|
Manufacturer's Information |
|
|---|---|
| Chemical Element | % Present |
| Copper (Cu) | balance |
| Manganese (Mn) | 0.3 typical |
| Nickel (Ni) | 4 - 6 |
| Iron (Fe) | 4 - 6 |
| Aluminium (Al) | 8 - 11 |
Alloy Designations
This specification covers material in copper alloy
Cu Al 10 Ni (U-A10 N) in use condition M
Temper Types
As Manufactured
Supplied Forms
Round Bar in full length or billeted/cut to length is supplied in sizes up to 280mm diameter.
- Bar
- Rod
Generic Physical Properties
| Physical Property | Value |
|---|---|
| Density | 7.5 g/cm³ |
Mechanical Properties
|
Manufacturer's Information - |
|
|---|---|
| Mechanical Property | Value |
| Proof Stress | 245-530 MPa |
| Tensile Strength | 650-805 MPa |
| Elongation A50 mm | 10-17 % |
| Hardness Brinell | 179-240 HB |
Download PDF
Last updated Friday, February 28, 2014
Disclaimer
This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.
Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.
The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed & online) and manufacturers’ data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources.
Material supplied by the Company may vary significantly from this data, but will conform to all relevant and applicable standards.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied.
Advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. All transactions are subject to the Company’s current Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.