Technical data sheets

Aluminium Alloy   |   BS-L

L110 T42 Sheet

Commercial2024 CLAD 1050A

Applications:
High strength fabricated or machined items in aircraft industries, general engineering, machinery, military equipment, truck wheels. Screw machine products. Structural applications. Rivets.

Characteristic Properties:
Heat treatable alloy. Very good machining characteristics. High strength alloy with a strength slightly higher than 2014(A) and 2017A and 2030. High fatigue strength. Suitable for welding only by resistance welding. Corrosion resistance only with cladding or other protection.


Chemical Composition

BS L110(1971)
Alloy L110
Chemical Element % Present
Aluminium (Al) balance
Lead (Pb) 0.05 max
Nickel (Ni) 0.05 max
Tin (Sn) 0.05 max
Chromium (Cr) 0.1 max
Titanium + Zirconium (Ti+Zr) 0.2 max
Zinc (Zn) 0.2 max
Iron (Fe) 0.5 max
Silicon (Si) 0.5 max
Manganese (Mn) 0.3 - 0.9
Magnesium (Mg) 1.2 - 1.8
Copper (Cu) 3.8 - 4.9

Alloy Designations

Aluminium alloy L110 - 2024 clad 1050A is covered by standard BS L110 (1971)


Temper Types

The most common temper for L110 - 2024 clad 1050A aluminium is:

  • T42

Supplied Forms

L110 - 2024 clad 1050A aluminium is supplied as sheet and strip

  • Sheet
  • Strip

Generic Physical Properties

Physical Property Value
Density 2.79 g/cm³
Melting Point 640 °C
Thermal Expansion 23.10 x10^-6 /K
Modulus of Elasticity 73 GPa
Thermal Conductivity 121-193 W/m.K

Mechanical Properties

BS L110(1971)
Sheet - 0.4mm to 0.8mm
Mechanical Property Value
Elongation A50 mm 12 Min %
Tensile Strength 390 Min N/mm2
0.2% Proof Stress 235 Min N/mm2

Download PDF
Last updated Thursday, January 9, 2014


Disclaimer

This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.

Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.

The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed & online) and manufacturers’ data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources.

Material supplied by the Company may vary significantly from this data, but will conform to all relevant and applicable standards.

As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied.

Advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. All transactions are subject to the Company’s current Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.