Technical data sheets
Aluminium Alloy | BS-L
3L58 'O' Wire
3L58 cold drawn and fully annealded soft wire rivet stock
Chemical Composition
|
BS 3L58(1971) Alloy 3L58 |
|
|---|---|
| Chemical Element | % Present |
| Aluminium (Al) | balance |
| Lead (Pb) | 0.05 max |
| Tin (Sn) | 0.05 max |
| Copper (Cu) | 0.1 max |
| Nickel (Ni) | 0.2 max |
| Zinc (Zn) | 0.2 max |
| Titanium + Zirconium (Ti+Zr) | 0.2 max |
| Chromium (Cr) | 0.25 max |
| Silicon (Si) | 0.3 max |
| Manganese (Mn) | 0.5 max |
| Manganese + Chromium (Mn+Cr) | 0.1 - 0.5 |
| Iron (Fe) | 0.5 max |
| Magnesium (Mg) | 4.5 - 5.5 |
Material shall be supplied annealed.
Alloy Designations
Aluminium alloy 3L58 - 5056A is covered by Standard BS EN 3L58 (1971)
Temper Types
The most common temper for 3L58 - 5056A aluminium rivet stock is cold drawn and fully annealed/fully soft
- O
Supplied Forms
L58-5056A aluminium is supplied as cold drawn wire for rivet stock
- Wire
Mechanical Properties
|
BS 3L58(1971) Wire - |
|
|---|---|
| Mechanical Property | Value |
| Tensile Strength | 265 Min N/mm2 |
Material shall be subjected to a torsion test. This specification was declared obsolescent on 01 April 1999. It is susceptible to intergranular corrosion.
Download PDF
Last updated Thursday, January 9, 2014
Disclaimer
This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.
Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.
The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed & online) and manufacturers’ data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources.
Material supplied by the Company may vary significantly from this data, but will conform to all relevant and applicable standards.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied.
Advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. All transactions are subject to the Company’s current Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.